12/23/2023 0 Comments VueScan + x64 9.8.14 for apple instal![]() ![]() To do this, go to the service menu, then to the → "Green Engineering Menu", then → "debuggung mlp" and select the "Ethernet" item.Īfter execution, it is necessary to reboot the GU, done by holding the shutdown button for at least 10 seconds.Īfter rebooting, go back to these partitions and tick the "Switch to MLP" section.ĥ) Set up an Ethernet connection and check the correct connection ![]() Performing steps 1,2,3, you need to enable Ethernet. If you see the PQ or ZR after the make of the car or the letter T at the end in the SW Train version, then you have a Technisat Preh device.Ģ) Updating the module from 0890 to 0891Theģ) Activation of "Green Engineering Menu" in the service menuToĭo this, take the wire (In my case, Washu), go to Block 5F → AdaptationĤ) Activate Telnet connection to connect USB network cardAfter = Delphi Unit If there is a letter D at the end of the SW Train version, then you have a Delphi module. T o do this, you need to hold the "Menu" button on the GU (head unit) for a few seconds, after which you will go to the service menu, where the "Update" section you can see the current version of your module and the type of module.įrom the photo you can see that I have a Delphi module, because in the line "Train version of the installed software" at the end is put "D" A little courage, because having failed or done something wrong, get ready for the expense of $ 400 +ġ) The first thing to do is to check that you have the Delphi module. ![]() USB network card D- Link DUB-E100 b1, c1, d1 (E - does not work, checked) ![]() VAS5054, VASYA or something that can change the encoding in the block To activate the voice assistant you need: cp off, patch.updating the firmware of MIB2 / MST2 Delphi Activating voice control.Apple CarPlay.Google Android Auto. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |